There's a problem: you're gonna hit the ceiling with your head (unless you live in a mansion with 18ft ceilings).

FInally (on the subject of the clipping) I would have shown you the waveform on a scope, going into the pre-ISF EQ stage, but my amp is no in bits (a lot of the inter-PCB ribbon wiring fell off) and so I have yet to put it back together.Change country: -Select- Afghanistan Albania Andorra Anguilla Antigua and Barbuda Armenia Aruba Austria Azerbaijan Republic Bahamas Bangladesh Belarus Belgium Belize Bermuda Bhutan Bosnia and Herzegovina British Virgin Islands Brunei Darussalam Bulgaria Cambodia Canada Cayman Islands Costa Rica Cyprus Czech Republic Denmark Dominica Dominican Republic El Salvador Estonia Finland France Georgia Germany Gibraltar Greece Greenland Grenada Guatemala Guernsey Haiti Honduras Hong Kong Hungary Iceland Indonesia Ireland Italy Jamaica Japan Jersey Kazakhstan Kyrgyzstan Laos Latvia Liechtenstein Lithuania Luxembourg Macau Macedonia Malaysia Maldives Malta Moldova Monaco Mongolia Montenegro Montserrat Nepal Netherlands Netherlands Antilles Nicaragua Norway Pakistan Panama Philippines Poland Portugal Puerto Rico Republic of Croatia Romania Saint Kitts-Nevis Saint Lucia Saint Pierre and Miquelon Saint Vincent and the Grenadines San Marino Serbia Singapore Slovakia Slovenia South Korea Spain Sri Lanka Sweden Switzerland Taiwan Tajikistan Thailand Trinidad and Tobago Turkey Turkmenistan Turks and Caicos Islands United Kingdom United States Uzbekistan Vatican City State Vietnam Virgin Islands (U. I can't help notice this circuit looks like the clipping stage in the classic Ibanez Tube Screamer pedal - just compare it with the circuit in 1. As the GAIN VR1 is increased, the guitar signal will be more amplified and eventually will start to clip. It’s still my after hours faffing / Zoom meeting / waiting for Godot amp, sitting at the back of my desk for at least the last four years.

I modded my fly 3 power simply enough, I rerouted the wires for the battery compartment and hooked them into a standard 2. Andertons Music Company is authorised and regulated by the Financial Conduct Authority, firm registration number 716155. Main problem is connecting a switch back to the Main Board which would need a second cable or wires. In this case it comes out of the power amp Ground connection on the Speaker Board and back to IC9 and beyond. These speakers have different sounds for all sorts of reasons, but one of the main ones is that the construction and electrical characteristics mean certain frequencies peak or dip.The designers needed to be sure the voltage from either batteries or external could never go above 6v so the whole thing didn't fry (creating that lovely foul smelling smoke you get when an IC incinerates). The 3″ full-range speaker is good enough for listening to music, but I’d like it to have more punch and clarity with guitar. This circuit is obviously there to provide current into the LED and light it up (and a LED is just a type of diode which glows with a colour when it conducts).