I have reported my findings on this product as honestly as I can but I was surprised the lengths the manufacturers have employed to try and have my copy altered to reflect their own view, which is that this product is a perfect replacement for the old formulation.

However, Nitromors is a non-drip gel consistency and can, therefore, be used on indoor vertical surfaces such as doors, stair spindles, and window frames etc. Of course one of the great advantages of chemical striping is that you don’t have to vaporise lead-based paint or other hazardous material, and you don’t create dangerous lead-based dust. Leave for 5-10 minutes to allow the paint or varnish to blister and then apply a second coat of Nitromors to the bolstered surface.Your health and safety is always a priority whenever you’re carrying out DIY projects in your home, especially when using chemical products like Nitromors. So here are the tips to prepare: Nitromors is a chemical product and, as such, should be treated with great care whenever you’re working with it. Always work in a well-ventilated area (ideally outdoors), as the fumes from Nitromors are considered a health risk. Here are the safety warnings for Nitromors paint remover: Removing paint with a heat gun is perhaps the most effective method, but it’s a quite slow and lengthy process. To achieve the best results for your new paint, apply a primer to the surface first so that the paint can easily bond to it

So removing this troublesome surface has been an ongoing job that I have to psyche myself up for. That said it has given me the ideal place to test sanders, hot air guns and chemical strippers. Besides this, another thing needed in spades for the product to work is patience. We’ve seen many users online complaining about the poor quality of this paint remover. In reality, the product isn’t bad, it just needs time to penetrate and soften the varnish or paint. So you will inevitably get a variable result in terms of time and effort needed to strip any given surface.Once paint has blistered, apply a second coat. Agitate with a wire or nylon brush as appropriate. Leave up to 40 minutes. If dried out re-apply The new Nitromors formulation worked surprisingly well on the varnish but on other surfaces not as well as the pre-legislation product. If you don’t have the patience to remove paint via sanding or heat, the only option is to invest in a quality paint stripper. You can indeed paint after using Nitromors, but you’ll need to make sure that you’ve properly prepared the surface for repainting. After using Nitromors and leaving the surface to completely dry out, you then need to: