By mixing Mapei Keracolor SF with Mapei Fugolastic, a special synthetic resin-based polymeric admixture, its final characteristics are further improved and it reaches a level of strength which makes it suitable for even the most severe service conditions (grouting façades, high demand leisure pools, power showers and even floors subject to intense traffic). Mapei Keracolor SF together with Fugolastic admix may also be used for grouting joints in marble to be polished after laying. Applying the grout: Fill the joints with the Mapei Ultracolor Plus mix using a special MAPEI grout float or rubber squeegee, without leaving any gaps or steps. Remove any excess of Mapei Ultracolor Plus from the surface, by moving the float diagonally to the joints while the mix is still fresh. For interior and exterior wall and floor grouting of ceramic tiles, porcelain, terracotta, stone material, glass and marble mosaics

In addition to color scheme, you want to think about maintenance. Unfortunately, grout color is hard to maintain. It’s hardest to maintain in areas that have high traffic and/or where the grout is frequently getting wet. Think of floors, behind sinks and in the shower. If the cleaning operation is carried out too soon (the mix is still too wet), some of the mix may be removed from the joints. If grouting is carried out in extremely hot, dry or windy weather, we When resistance to acids or, where extreme cleanliness or sterile conditions are required, use a suitable acid-resistant epoxy grout.Mapei Ultracolor Plus does not contain Portland cement and must not be mixed with gypsum or other hydraulic binders; never add water to the mix once it has started to set.

All Mapei Ultracolor Plus grout colours are also available in a matching silicone – Mapesil AC Silicone. If using this grout with moisture sensitive natural stone tiles, a low modulus silicone is advised – Mapei Mapesil LM Silicone. Our FUGA-PAVE Flex CH grout is part of our FUGA-PAVE ABC system, formulated for landscaping professionals and ideal for use when installing porcelain, natural stone, cementitious flags, cobbles, or in fact any external installation. FUGA-PAVE ABC is very simple to use. Just mix Part A (hybrid mortar cement) with suitable clean grit sand and water. Part B (slurry primer) and Part C (hybrid grout) are each mixed with clean water. No other additives are required. This complete system offers various cost and installation benefits, beating the traditional system. Do not mix Mapei Keracolor SF Tile Grout with cement or other products, and never add water once it has started to set.If the cleaning operation is carried out too soon (the mix is still too runny), some of the mix may be removed from the joints which makes them more subject to changes in colour. On the other hand, if the grout has already set, it will have to be cleaned mechanically which may cause scratching on the surface of the tiles. Grouting narrow tile joints in all types of tiles on floors and on walls in buildings for domestic use.