This wire is usually 2.5mm diameter and is used to “bind” the straining wires to the line posts or standards as they are also known. This is done by passing the binding wires through holes in the intermediate posts before twisting the ends together. Tie Wire

Diamond mesh and rolled welded wire mesh fences in warmer climates don’t have top rails, but they still need something to support the wire mesh. Unlike North American fences, where tie wires are often pre-bent (and used to secure the mesh to line posts and top rails), tie wire in warm weather mesh fences is used to tie the mesh to the straining wires.

Galvanised Straining Line Wire is manufactured from steel which has been galvanised with a zinc coating to help it withstand the elements, resist rust and corrosion, and remain strong. The wire is used to ensure that the top of fence netting or mesh is tensioned and taut, providing strength and helping to prevent damage to the fence by animals or vandals. This wire is also available with a PVC coating for use with PVC-coated fencing. Use a stretcher bar to ensure equal tension in all lines, or use two wire strainers in tandem: strain up and fix the top and bottom wires, then work inwards. Walk the line of the fence explaining what work will be undertaken. Identify potential hazards and explain how to work safely around them. Lay out materials, describe any potential problems and indicate the positions of the straining posts (decide upon these now if you have not already done so). Demonstrate tool use

Changes in direction can be made by cutting and sinking in the rails into the post. Post and wire fencing At each change of direction of the fence, sever the roll by untwisting the spiral next to the stretching bar, do this before you insert the stretcher bar. In warmer climates, many rolled wire mesh fences do not have top rails like they do in North America, and since it never freezes, it’s perfectly okay to have holes drilled in posts. Here’s how the various types of wire used for this type of fence are an important part of the structure. Straining wire The next kind of wire that is used on warm weather diamond mesh or chain link fences and rolled welded wire mesh fences is binding wire.Locate the straining and turning post holes accounting for changes in slope and direction of the fence line. Digging a post hole To finish off, saw off any minor damage to the posts, nail up splits and ensure cut wire ends are sunk into the posts. Rabbit netting, chain link and palings Demonstrate all new work techniques as you come to them. This will save mistakes and avoid accidents.

If you’re building a warm-weather diamond mesh or rolled welded mesh fence, chances are you’re going to need a few different types of wire to construct the fence structure. When using a drivall be particularly careful that the post is upright and the people using it wear safety helmets. Straining and stapling Nail the rails with galvanized nails driven in at an angle, ensuring the nails are not directly above one another and are set a few centimetres apart. Work out the exact line of the fence and the positions of the straining posts. These are usually determined by the lie of the land (a post at every change of direction or major change of gradient), but straining posts can be up to 110m apart, although 50m is preferable.Concrete and Timber Posts - ensure that the straining wires are evenly spaced between top and bottom edge of the fencing (about 100cm down from the top of the fencing up 100cm up from the bottom). Loosely fit the end eyebolts and stretcher bar cleats with nuts (with large washers on both sides of the post), use two cleats and eyebolts with ring-nuts on intermediate straining posts.