Of course, you're going to need to do something about that lower half of yours, since it needs to be a little more horse and a lot less human.

The axle running from wheel to wheel is half inch all thread, running through half inch PVC T'd off from base of vertical support. I choose a little bit more furry fabric since this was my first creation and it was definitely more forgiving where the seams were. Personalised advertising may be considered a “sale” or “sharing” of information under California and other state privacy laws, and you may have a right to opt out. Some of the technologies we use are necessary for critical functions like security and site integrity, account authentication, security and privacy preferences, internal site usage and maintenance data, and to make the site work correctly for browsing and transactions.

I then mounted this to the cooler with zip ties that mounted through holes i drilled through just the outer layer of the cooler. The first thing I did was what anyone would do … consult Google of course to see how other people mastered this challenging costume.

Of course, you’re going to need to do something about that lower half of yours, since it needs to be a little more “horse” and a lot less Homo sapiens. The section in the middle is for support–also to hold the foam in place (we’ll cover that more later).NOTE* I ran the zip ties for the wig around the PVC BEFORE I put the fur on and snipped holes in the fur where needed for zip ties to run through. That way, when the offset bolt rotated, it would drive the upper part of the leg up and down like a piston.