Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). c) With the same measured solution as above, gently wipe the whole area again to remove any remaining mould residues. or similar is to be used then it should be hung after the Dryzone 100 Mould Remover has fully dried. Add Kingfisher Anti-Mould Paint Additive to almost any standard emulsion to make your own anti-fungal paint that matches the existing paint finish perfectly!

I’ve had mould problems in the back bed room for years with only varying success with other products. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging . Here at Advanced Chemical Specialities we offer a wide range of quality and affordable anti mould paint additives. Once cured the product leaves an “active film” fungicide which is hostile to mould spores and therefore permits re-decorating with confidence that mould will not re-grow.Leave the surface to dry (this should take approximately One hour) and ideally paint within 7 to 10 days of pre‐treatment. This provides peace of mind that the contained biocides are approved for use and safely incorporated into our products. Do not overcoat the anti-mould finish (or wallpaper over it) as this will effectively seal in the mould-resistant finish and allow the mould to grow back. This product will help clean and kill off very heavy growths prior to application of the AdPaint treatment. This pack contains all you need to convert an ordinary decorative paint into a mould resistant coating for walls and ceilings.

With PermaPROTECT Anti Mould Paint Additive you get lasting protection from black mould as well as your desired decorative finish. If you have any questions about any of the products that we supply, please don’t hesitate to get in touch with a member of our team today! Dryzone Mould-Resistant emulsion Paint Additive adds mould-resistance to gloss paints, wallpaper paste and grouts preventing the growth of mould on the dried surface.

Add 60g to 5 litres or 120g to 10 litres of emulsion paint by stirring in (ideally with a mixing paddle on an electric drill) and apply by brush or roller to create a “mould hostile” decorative finish. While anti mould paints are perfect for preventing mould from developing on surfaces, painting over an already mould area will not solve the issue.

Note: Clean any non‐mould related contamination by wiping with a damp cloth and or sugar soap as required. Alternatively, if the affected area is showing signs of salt contamination (white fur) you may have rising or penetrating dampness and you should seek advice from a structural waterproofing professional. It is ideal for stopping mould growth on walls and ceilings in properties where it is not possible to carry out more expensive measures to stop condensation. Add PermaPROTECT Anti Mould Paint Additive to any paint type to create a powerful mould resistant coating. a) The “Mould Cure” bottle comes with a built–in measuring cup, remove the lid, hold upright and squeeze gently to measure out 25 ml four times (100ml) and add to 400ml of warm (Not hot or boiling) water.It can also be added to our “Kingfisher Weatherflex range of masonry paints in areas where green mould growth is prevalent on building exterior.