This wood paste is well suited for facing-off beam repairs where the uncured material may be grained to match the existing timber and for filling in tack damaged, rotten or woodworm infested furniture and similar items. Professionals to the do-it-yourselfers select PC-7 because of its exceptional adhesion to metals, ceramics, masonry and many plastics.

When the gelcoat is at the 'b-stage' you could apply the paste directly onto the gelcoat or, if the 'b-stage' felt less tacky than you'd like you can use some of your laminating resin as a coupling coat to wet-out that bond a bit. Professionals to the do-it-yourselfers select PC-7® because of its exceptional adhesion to metals, ceramics, masonry and many plastics.RESTOR 22 remains in place on contoured and vertical surfaces, and, on cure, forms strong bonds to most structural materials wood, metals, and glassfibre reinforced laminates. Our team are also artists, so we have experience using our items first-hand; we’ve put them to the test time and time again for wall art, jewellery and timber table creations.

Some of the technologies we use are necessary for critical functions like security and site integrity, account authentication, security and privacy preferences, internal site usage and maintenance data, and to make the site work correctly for browsing and transactions. It is easier to say what PC-7 will NOT bond to: Wax paper, teflon, plexiglass, vinyl and some softer plastics.However, for mixing purposes we always recommend adding the pigment to the resin part BEFORE adding the hardener to allow you plenty of time to properly mix, so that means you will just need to plan ahead slightly so you know what your total resin and hardener mix will weigh. Before applying Industrial Metal, surfaces should be free of paint, rust and grime before being roughened up through either grit blasting or grinding with a coarse wheel or abrasive disk pad.

Before applying Industrial Metal Rapid 5 Minute, surfaces should be free of paint, rust and grime before being roughened up through either grit blasting or grinding with a coarse wheel or abrasive disk pad.Being an epoxy based mould making system, EMP60 is ideally suited for use when making epoxy based end products (like carbon fibre parts or epoxy matrix GRP/FRP). It is reinforced with corrosion-resistant metal platelets which provide good protection for surfaces in aggressive environments against corrosion and chemical attack. The two parts are differently coloured, simply mix until you can no longer distinguish between the two colours.