When taking a digital thermostat from a cold van and installing it in a warm home, you should be aware that it won’t respond instantaneously.

The red LED light will flash for approximately 7 seconds to tell you that the two units are initialising. This confirms that the radio signal is being sent and received. The industry recommendation for a room thermostat is 21˚C, but this may need to be adjusted if there are health considerations or elderly occupants that require a warmer environment. When used with a gas boiler the Digistat will automatically cycle the boiler to help your boiler to run more efficiently and save you 10% on your heating bill (compared to a simple ON/OFF thermostat).

LP722

When used together, the frost and pipe thermostats ensure that the boiler is automatically switched on when the temperature drops to a dangerous level and runs until the system water temperature has been sufficiently raised.

The app will allow complete control over time and temperature in individual rooms around the home, wherever and whenever you wish. The Digistat remembers the last BOOST so if you always use the same parameters just press the O button once. Simple! First, remove the valve head, then, use the presetting tool to unscrew the gland seal. Finally, screw in the new gland seal remembering not to over tighten. Now you’re done you can re-attach the valve head.

Drayton Explains – HOW TO BECOME HEAT PUMP QUALIFIED

Reset the Digistat thermostat by going into the setting menu, selecting the Inst03 menu (installer settings) and then rSEt20 to reset to factory settings. Then remove the batteries. When batteries are running low, a low battery icon will flash in the display. During this time, miGenie will function normally. For example, if a householder understands when their heating is due to come on and when it is scheduled to be off, as well as how to alter the time settings, then they should be able to manage their system timings without your assistance.