Universal Junction Box Deep Base for Security Surveillance Cameras, Full Aluminium Metal, Waterproof Cable Hidden Box for CCTV IP Camera Dome and Bullet Type (Black)

Product Information

IP-A4BZ 4mp bullet IP camera mounted to the junction box. This junction box works with most of our bullet style Viewtron IP cameras. Junction Boxes, by definition, almost always require cutouts and breakouts to perform their function. Most junction boxes require cutouts for cables and wires entering and exiting the enclosure. However, this also means the chamber maintains a NEMA or IP rating at cable entry and exit. Digital Printing CCTV Camera Junction Boxes BIPRO-9004 bullet camera. Please note that the VT-J302 can be used as a wall mount or ceiling mount for dome cameras and bullet cameras. Number two, when you’re installing on the exterior of a building you’re using either Tapcon screws in the case of CBS construction or concrete construction, or some type of sturdy anchor in the case of wood-frame construction. And so if you ever needed to take your camera down to troubleshoot or replace it, these exterior cameras don’t last forever, even the best ones that we sell, you’re eventually going to replace these things, you don’t want to be dealing with permanent Tapcon screws or anchors. So if you Tapcon screw the junction box to the wall and then you use the pre drilled machine screws to mount the camera to the junction box, it’s a very simple operation to later remove that camera with the machine screws, the junction box stays intact with the Tapcon anchors and you don’t have to deal with that. Here is an installation that shows how to use wire conduit with the junction box. There is a pre-drilled and threaded hole for 1/2 inch conduit. This is the 4.6 inch model junction box. The larger 5.5 inch model supports 3/4 inch conduit.

gray camera junction box (model VT-J302G) Here is a picture the VT-J302G junction box used to mount a Unless selecting a vari-focal camera (with an adjustable lens) It is important to select the correct camera lens option for where the camera is to be positioned. A smaller lens will give you a wider angle but will be "zoomed out more", while a bigger lens will narrow the angle down and "zoom in more". See below to give you some idea on angles of Megapixel HD Cameras: Junction Box, The junction box’s size is also a factor in the selection. The Junction Box Sizing Guide, which includes standard junction box sizes for the National Electrical Code, covers this topic in detail. Commercial junction boxes are usually larger than residential ones because they often contain multiple connectors. The installation chain that holds the cover plate to the base is very useful when you are connecting your camera to the cable. The chain also makes it easier to get the excess cable and connectors organized on the base housing before attaching the plate to the base. If you have any questions about any of this you can reach out to me anytime, I can be reached at [email protected]. If you want to learn more about these junction boxes we have four and a half inch round and five and a half inch round, the four and a half inch are for smaller dome cameras, and the five and a half are for bullet cameras and bigger domes. You can learn about both these, just go to www.cctvcamerapros.com/jbox.The pre-threaded screw holes are used to mount the camera to the cover plate of the outdoor junction box. As a rule of thumb, we recommend 2 Terabytes for a 4 x 4/5MP HD camera setup, as this should give you approx 2 weeks using H.265 @ 20fps and that is on continuous, not motion-detected recording. License Plate Reader Cameras - Our Viewtron LPR cameras and NVRs have built-in automatic number plate recognition software that reads the numbers and letters on license plates.

gray CCTV junction box available (model VT-J301G). The specs are identical to the white version. The only difference is the color. Here is the DPRO-B24DHR turret dome CCTV camera mounted on the VT-J301G. Please note that these mounts support ceiling or wall mount installations for dome cameras and bullet cameras. Commercial Junction Boxes are typically mounted on a wall or other flat surface. Mounting hardware is required to mount the junction box securely. Mounting feet and flanges are the most common way to add mounting hardware to electrical junction boxes. installation examples that use this junction box. You can also watch this video where Mike explains many of the benefits.Here is the VT-J302 outdoor junction box mounted to a metal pole. The camera that is attached to the mounting box is our Almost all modern electrical systems require a CCTV camera junction box. However, commercial electrical systems are often subjected to harsher conditions than residential systems. Specifying a junction box model built to stricter standards and with commercial features for commercial applications is essential. IP cameras with AI software - dome and bullet style. We also a 4K bullet with motorized varifocal lens. Here is a picture of a bullet camera mounted to the junction box that uses a 3 hole mount pattern. The VT-J301 works with most smaller bullet-style CCTV cameras.

Narrows down the angle and zooms in to look past the immediate area a little to gain more detail - down a driveway for example from higher up The amount of hard drive space you require is dictated by how many cameras, as well as their resolution, frame rate settings, and whether you have H.265 encoding enabled or not to save space (We advise turning it on to double the capacity shown below with ease). VT-J302 outdoor junction boxes. The 2 cameras installed higher up on the pole are overview cameras in our LPR application. Refer to your local electrical code to determine if you must use a specific NEMA or IP-rated outlet. In most cases, a commercial electrician or technician who works on electrical installations can tell you the correct NEMA or IP rating as required by local codes. Custom Cutouts/BreakoutsThere is enough room in these weatherproof junction boxes for BNC connector, RJ45 connectors, and power supply connectors. You can see that this camera installation uses the pre-drilled conduit hole available on the VT-J301 junction box. From brainstorming with the team, to finding the right product, to having all the documentation and videos available to implement it flawlessly. You can also use the Hikvision online calculator to work out what works best for you specifically: https://tools.hikvision.com/ca...

Here is a larger picture of the pole. You can see that we have two additional cameras installed higher up on the pole using 2 additional Finally, you can often make your storage space last a lot longer by enabling motion-detected recording rather than continuous, especially if there are long periods of no activity (to perhaps double or more these figures again). You may only require the full 25 frames per second on certain cameras if things are fast-moving - ie above a till) For seeing as much of the immediate area as possible such as above a doorway/low down/garage soffits (edges can appear slightly warped/distorted) - clearly "zoomed out" I am a facilities manager and have been using CCTV Camera Pros for a couple years now. It all started a couple of years ago when I found you guys on the internet, and bought a 16 channel DVR from a guy named Chris Haldas (related I’m guessing).

Junction box housings can make of metal (usually aluminium or stainless steel) or plastic (usually polycarbonate or ABS). Choosing between a plastic and a metal junction box is one of the first critical decisions in specifying an enclosure type for commercial applications. According to the white-paper released by milesight, a Junction box is a metal container for electrical connections, designed for not only concealing cables/connectors but also deterring tamper. The metal junction box is part of an electric conduit wiring system, it not only can be filled with an adapter, you also can put a lighting/surge protector to prevent your entire CCTV system against from possible lightning or surge. Comparing with a bunch of exposed electrical wires which can be easily cut, using junction box your CCTV system not just looks professional, but also has better reliability. The general appearance of the box is either square or rectangular, most of them are made of ADC12 Aluminium alloy which features high tenacity and can withstand tough strength. #2 Advantages of using junction box A great general purpose option giving great coverage still in the corner of a room or higher up on second floor soffits with less distortion - more of a natural "zoom" By using a junction box for your exterior camera installation, your camera is much easier to maintain and later replace. IP-D8 4K dome IP camera mounted to the junction box. This junction box works with all of the smaller model Viewtron IP cameras.