Rust-Oleum AMZ0012 Chalky Finish Furniture Paint - Antique White - 750ml

Product Information

If you want to achieve a distressed finish on your piece of furniture, apply one coat of the base colour, and one coat of the top colour. Create a distressed look by applying two coats in contrasting colours then sanding/ scouring when dry. Water based, no priming or sanding necessary on most surfaces. Preparation: For best results, ensure surface is clean and free from wax or oil. If wax has been used clean the surface thoroughly with white spirit. We recommend that bare wood should be sanded before painting.

The popular finish for furniture paint is chalky. This gives a smooth flat low-sheen finish that has the feel of chalk. It's non-reflective and does a good job of hiding imperfections. Simply wipe down your furniture before applying a coat of the paint on top of bare wood, existing paint or varnish. Clean Up: Remove as much product as possible from application equipment before washing with water. Do not empty into drains orwater courses. Some local authorities have special facilities for the disposal of waste coatings. Drying Time: Touch dry in 2 hours. Apply a second coat after 2 hoursif necessary. Hard dry in 4 hours, full hardness achieved after 7 days. Coverage: Up to 12 - 14m2 / litre. Coverage may vary depending upon method and rate of application and porosity of surface.

Share this

If you are painting a chair, a brush is the best option to get into all parts. Start at the top and work your way down. Add a small screw in the bottom of each leg to keep it just above the ground to help paint the legs. Alternatively, turn the chair upside down, paint the legs, wait for them to dry, turn over and finish. Make sure to put down dust sheets or paper. For furniture with a lot of detail a good quality paint brush is recommended to ensure that you reach into any mouldings and cutouts. Application: Stir thoroughly prior to use. The product may be applied by brush or roller. If applying by bush, apply evenly following the grain of the wood. If rollering, use a nap mohair roller. To create a distressed look apply two coats in contrasting colours. Allow to dry then lightly abrade with moistened sand paper or a stainless steel scouring pad - abrade with the grain of the wood. Protect the effect with Rust-Oleum Furniture Finishing Wax. Preparation: For best results, ensure surface is clean and free from wax or oil. If wax has been used clean the surface thoroughly with white spirit. We recommend that bare wood, previously painted or varnished surfaces should be sanded before painting. Ensure new concrete is sound, fully cured and free from laitance. Coverage: Up to 14m2 / litre. Coverage may vary depending upon method and rate of application and porosity of surface.

coat over the affected areas, leave to dry, and then sand again until the desired finish is achieved. Whatever furniture paint you choose they are typically hardwearing, durable, wipeable, cover well, need little prep and are easy to apply. However, they're not all suitable for use outdoors, and you should investigate the best exterior wood paints for use in the garden. Tips for Painting Furniture Rust-Oleum Chalky Furniture Paint is perfect for upcycling old furniture into your new favourite piece! Application: Apply when temperature is between 10 and 30ºC. Stir thoroughly prior to use. The product may be applied by brush or roller. If applying by brush, apply evenly following the grain of the wood. If rollering, use a short nap mohair roller. Two coats are recommended. Perfect for upcycling, refresh your furniture with this Rust-Oleum Chalky Furniture Paint and give your old pieces a new lease of lifeFor a vintage look, distress your furniture with a dual tone effect using two similar colours, add a layer of Rust-Oleum Furniture Finishing Wax or Rust-Oleum Furniture Lacquer for the finishing touch Drying Time: Touch dry in 1 hour. Handle after 4 hours. Apply a second coat after 4 hours, if necessary. Full hardness after 4 hours.

Unwanted Food or Drink Products - Once supply conditions are broken, there are a number of factors outside of our control that can affect the quality of a product. Therefore perishable goods such as food and drink cannot be returned. Limitations: For interior use only. Temperature at time of theapplication and during drying should be greater than 5°C. To ensurepaint suitability for your particular project test on a small inconspicuousarea first. It might look small but each sachet is enough to give you a 30cm by 30cm test area and a true representation of colour and adhesion at home. Once the paint has dried, use a fine grade sandpaper and lightly sand down the areas where you want to see the base colour.

Then there is always the option to move away from white and subtle shades and invest in bold, bright colours to make your furniture stand out. For something completely unique take a look at stencils and use your imagination on how you apply them. For indoor furniture only it is nice and easy to apply - brush or roller - and is self-priming - just needs a rub down. But this does mean you will need at least two coats to cover properly. Drying time is just an hour and you can recoat within four hours in the right conditions. Wait another four hours and your furniture is ready to use.

Clean Up: Remove as much product as possible from application equipment before washing with water. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste coatings.

Stain Removal: Remove any stains promptly, most common stainse.g. dirt, ketchup, mustard, tea, coffee can be removed using a softcloth and warm soapy water. Do not use scourers or abrasive cleanersas these may mark the paint finish. Perfect for upcycling old furniture into your new favourite piece! Revive chairs, restore wardrobes or revamp an old chest of drawers with a smooth chalky matt finish in just one coat. No priming or sanding necessary beforehand.