3 Channel 5A DMX512 Controlled Relay Switch Kit DIY Converter DMX Dimmer Relay

Product Information

Simply connect hard-wired DMX (Multiverse SHoW Baby or Multiverse Node) or sACN (Multiverse Transmitter) to automatically send wireless DMX to any ColorSource Relay Multiverse Receiver within a 100-meter (328-foot) range. Take them out, plug them int output_1 = 5; // names the ESP8266 GPIO output pin we are using (5 is D1 !!!), don't change this for Relay Shield. One big thing- be sure you have a Micro-USB cable that supports DATA! Many are charging-only and don’t have the data wires. You may need to try a few cables! For customers in outlying areas of the country, the price of the Extended Warranty may be marginally higher, due to the potential for higher collection and redelivery transport costs.

While an Amp is an Amp, all fuses are not created equal. Using a 12v fuse in a 120v circuit is just a bad idea. It will likely melt or burn before it blows, and at a much lower current than it is rated for. Important: The D1 Mini can only access 2.4Ghz WiFi networks, not 5Ghz, so be sure to use an appropriate network.volatile byte aFlag = 0; // let's us know when we're expecting a rising edge on pinA to signal that the encoder has arrived at a detent First- replace “MyWiFi_SSID” with your WiFi network name (the WiFi network you are running your show from.) Be sure to keep the quotes.

You have almost unlimited E1.31 Universes, so the most straightforward way to do this if you are going to use multiple relays is just to use a Universe for each one. So “Relay 1” might be Universe 1, “Relay 2” would be Universe 2. You would just set “universe = 1”, and “channel=0” Channel 0 translates to “Red” on many light controllers, or it will actually be called “Channel 1”. Internally it is 0 though, which can be a bit confusing. You should get an instant answer on whether your application has been successful, though in some rare cases Klarna or V12 may need to look at the application in more detail.In addition you will also need the mateing plugs for CN7 & CN8. These are made from crimp housings 22-01-2065 (143-129) and 22-01-2035 (143-127) along with crimp connectors 08-50-0106 (101-2163). railSwitch is an elegant solution to the automation of various devices in theatre, touring and architectural markets. Applications include animatronics, fog machines, theatre practicals, cue lights and video remote control. Jumper selectable as DMX "sense" relay. When good DMX in, relay is closed, no DMX and the relay is open. You should use a separate show WiFi network, on a dedicated WiFi AP/Router. Don’t just add your light controllers to your home WiFi- you WILL have issues. I also recommend you set it up as a “hidden” network- look for a “Don’t Broadcast SSID” or similar option on your AP/Router. After a number of problems as my show grew in 2020- I found out you DO NOT want to waste universes like this. A show runner will send out all programmed universes, and generally all channels in that universe, so you can waste a huge amount of network bandwidth on almost-empty universes. You are better off doing the below- assign one universe to all your relays, and assign consecutive channels to them. Just remember to subtract 1 for the channel you assign on the D1 Mini…

That’s it- now you can go to Tools -> Board -> Boards Manager, and install the “ESP8266” boards. When done, you can select:

Key Features

void rotaryMenu() { //This handles the bulk of the menu functions without needing to install/include/compile a menu library pinMode(pinB, INPUT_PULLUP); // set pinB as an input, pulled HIGH to the logic voltage (5V or 3.3V for most cases)