Joined in 2023 
82 
63 About this deal
You may be asking, why have the standards been updated? Well, it is hoped that the changes will make for more precise testing and clearer marking of safety footwear that reflects more realistic real-world conditions and modern materials.
They should always be used, stored and transported with care and kept clean. In addition to following this guidance, it’s important you read and follow the user instructions provided by the manufacturer. Ladder grips fit all box section ladders, Improve your ladder's stability by up to 350% with Ladder Grips! The certification is valid for 5 years, so the standards will run side by side until all safety footwear is re-tested to the new standards. Products may be re-tested before the certificate expires, but there would be a cost associated with this so manufacturers are likely to leave it as long as possible. It has been advised that as of Q1 2024, all new safety footwear will need to be the new standard. A ladder grip test assess the suitability of the footwear for use on ladder rungs, and tests the area which rests on the rung (between the heel and forepart of the boot below the arch) to a fire-fighter standard. The symbol for passing this is LG. Puncture resistance test changed:
About Us
Don’t overload the ladder – consider your weight and the equipment or materials you are carrying before working at height Apply a 6mm diameter bead of the PU230 adhesive down the middle of each internal surface of the "Ladder Grip" profiles. do not apply Adhesive to more than 5 "Ladder Grips" at a time.
Dylan also pointed out that there are many examples of when workers' safety can be compromised by climbing up flat-rung fixed ladders attached to equipment such as fuel tanks. While all changes to the standards have significance, some are aimed primarily at the manufacturers. Therefore, here we have listed some changes that will likely impact you the most: Always grip the ladder and face the ladder rungs while climbing or descending – don’t slide down the stilesWhen deciding whether it is safe to carry out a particular task on a stepladder where you cannot maintain a handhold (eg to put a box on a shelf, hang wallpaper, or install a smoke detector on a ceiling), the decision needs to be justified, taking into account: The EN ISO 20345:2022 standard for safety footwear was updated in 2022. This supersedes the previous 2011 update (which will remain in place until Q1 of 2024).
Changes have been made in a number of areas – ranging from the requirements that footwear must meet to the test methods themselves. This also means that some standards have been revoked. Now – as the safety footwear standards have already been published, all new products will be tested to the new standards, and so will carry the new codes. Are the 2011 standards still relevant? Ladder rungs are specifically designed at an angle so they become level and provide stability when the ladder is put at the correct angle against a surface, but a lot of these types of fixed ladders have rungs which are round barred, with no angled flat surface or grip."The old symbol of WRU (meaning water-resistant uppers) has been replaced by a new code of WPA – meaning water penetration and absorption. Scuff cap abrasion resistance test added: Please ensure that the PU230 data sheet is studied before commencing the installation. Local conditions and circumstances may require some amendments. Outsole – this is the piece of material on the bottom of the shoe – generally a compound of rubber on a safety boot. ALL Scaffolds & Towers Domestic Towers STEEL Scaffold Towers ALLOY Scaffold Towers Industrial Towers
Great Deal 
New Comment