Stihl Chainsaw Engine Pull Rope Starter Cord 3.5 mm x 2m Start Lead

Product Information

You may also need to examine other Stihl hs80 hedge trimmer parts efficiently to see if there’s any other malfunction that is affecting the performance of your tool.

It’s also necessary to remove the starter cover from the hedge trimmer. This can usually be done by removing a few screws with a screwdriver. Step 2. Examine the Pull Cord Assembly So, the longer a spring sits tightened or wound, the more it loses its force as it starts to take the shape it is coiled in. This loss of force is one reason recoil starters don’t always work as well as a new spring.Cord Not Retracting: If the cord does not retract when you release it, it may be due to a damaged spring or cord, and both may need Stihl hs45 pull cord replacement . Related: How to Grease STIHL Hedge Trimmer Frequently Asked Questions 1) Can you replace the cord on a hedge trimmer?

Remove the saw frame from the stand and remove the old pull cord. Screw in the new pull cord by tightening the three screws that you removed. Take the new cord and thread one end through the hole in the center of the assembly. Tie a knot at the end of the cord and pull it tight.

more about start systems

Over time, the pull cord can become worn or broken. If this happens, it may be difficult to operate the chainsaw. If you notice that the pull cord on your Stihl MS 180c chainsaw is worn or broken, you should replace it as soon as possible. Next, use your nut driver to remove the center bolt holding the metal/plastic disc in place. Then, lift off the disc and remove the two pawls. You can set these parts aside for later. Remove the Rotor Pulley

If yes, you definitely have the golden chance to perform this job at a very low cost. There’s no need to speed even a single penny on a hedge trimmer specialist. To remove the spring, grab a pair of pliers, like a pair of needle nose pliers, and grip the spring so that you have hold of the inside coil, outside coil, and all the inner coils. Then pull the spring from the old pulley. Swap Out the Rotor Pulley & Install the Recoil Spring Put the new cord through the same hole in the pull starter reel where you took the old rope out from. Make sure to put the rope through the top of the rope so it comes out from the bottom. Overall, substituting the pull cord on your Stihl Hedge Trimmer can improve your equipment’s functionality. It’s a small but significant repair that can make a big difference in the performance of your hedge trimmer.Reattach the saw frame to the stand, making sure that the screws are tight enough so that there is no chance of the cord coming loose again.