Joined in 2023 
82 
63 About this deal
The other option involves meshing the entire window with galvanized wire mesh held in place with silicone. The Department of the Environment, Food and Rural Affairs (DEFRA) is the UK’s Government body that oversees the Wildlife and Countryside
The following manufacturer’s product description is for the ‘QB-4 ultrasonic bird and bat repeller’: First you will need to measure the length of the gutter, which can be done by pacing out the relevant wall of the house at ground level. This will provide a rough measurement. You will then need to cut two pieces of galvanized steel mesh the length of the piece of guttering you wish to protect. The width of these pieces will be dictated by the overall size and width of your gutter. On some period buildings guttering can be extremely wide and in other cases there will be a square lead-lined gutter. In each case this method will be effective and the principle of installation is the same as for a conventional modern gutter. All balconies will have a balcony rail and protective safety panel that are, in most countries, a legal requirement. The safety panel or railing will normally be constructed from either glass, concrete, wrought iron or steel. In the case of wrought iron or steel it is unlikely that the safety panel will be solid, thereby giving free and easy access to pigeons through the ironwork or steelwork. The safety panel on most types of balcony will leave a gap just above the balcony floor allowing pigeons to land on the lip of the balcony floor and walk into the balcony itself. The only exception to this rule would be where the balcony is made from cast concrete – in this case the floor and walls of the balcony would be integral, leaving no gap for pigeons to enter the balcony recess at floor level. As all balconies will have a handrail, or in the case of concrete balconies the top of the outside wall, pigeons will use the handrail or the top of the wall as a staging post, just as they do with the gap between the floor and the base of the safety panel. The most straightforward DIY method of stopping pigeons perching on horizontal pipework is to install a thin piece of plywood, or any other similar material, above and sloping down over the pipe at such an angle that pigeons will be unable to continue to perch on the pipe. The installation will be a permanent fix once installed and may actually improve the aesthetics of your property by merit of hiding ugly pipework.
Of all the balcony types this is the easiest to protect, whether conventional pigeon deterrent products are used or whether DIY options are considered. Having said this, and irrespective of whether the balcony is recessed or sits proud of the fascia of the building, if balconies to either side or above/below your balcony remain unprotected, pigeon-related activity is likely to continue irrespective of what action you take.
If you want to take extra caution you can have a listen to the hearing test below and see what frequency ranges disturb you, your family, or any of your pets: product may appear to be reasonably priced based on the various options available to the user and relative to some of the more cost-prohibitive exclusion productsCombines a sensors, ultrasonics, flashing strobe light to chase away unwelcome animals from your garden
Birds generally fall within the range of 1,000 Hz to 4,000 Hz. Pest birds like pigeons and seagulls are exceptions to this range. Ultrasonic bird repellents rarely work on them, but other repelling techniques may. Safety Humans If the horizontal base of the (wooden/UPVC) window frame itself is wide, as is often the case on period properties, it may be worth considering protecting this area with another wire as it is not uncommon for a pigeon to perch or roost on the base of the frame once the sill has been fully protected. This is particularly the case if the pigeon/s has been using the sill for overnight roosting for some considerable time or has previously bred on the windowsill. but also give greater focus of protection for intensive use such as horticulture, viticulture, fish-farming or on factory roof tops or along airport runwayswith the device in this application would be its ability to deter the target species. A number of branded sonic and ultrasonic scarers are recommended for There is a DIY pigeon deterrent solution to this problem that will not only protect your guttering from pigeons but also prevent the build up of natural debris such as leaves and twigs, thereby making it a good option whether or not you have pigeons on your property! The principle of this installation is to install a semi-circle (or rough triangle) of combination of ultrasonic and audio speakers and is powered by a standard 12 volt battery. It is controlled by an external plug-in hand-held
review it is these systems that we will concentrate upon. A majority of these systems are static systems with multi-speaker options that would normally be used Another area of your rainwater goods that may need to be protected from pigeons is the ‘hopper’, a V-shaped plastic or cast-iron funnel that connects your horizontal gutter to the vertical downpipe. Pigeons will use hoppers for both roosting and for nesting. It is common to find a pigeon nest built inside a hopper, particularly on period properties that have large cast-iron hoppers.
BIRD CONTROL SALES AND INSTALLATION
Suppliers of sonic scarers suggest that the product can be used in virtually every urban situation and for the control of most species of bird.
Great Deal 
New Comment