Rawlplug Timber Uno Universal Wall Plugs - Eco Friendly - Made from 70% Wood (Yellow 5x24MM)

Product Information

To improve things even further, Plasplug also make a hook with the fixing included to make your life even easier, this particular product can be seen in the image below. Note: If you are unable to dislodge the rawl plug from the wall, you can insert a screw into it, tighten it and then look to pull both the rawl plug and screw out with the claw end of your hammer.

When it comes to actual physical fixings, these are the best fixings DIY Doctor have found for this job. The fixings in question are made by Plasplug and can be seen in the image below. A deep thread extends right up to the head, making it good for wood as well as chipboard. Coach bolt (cup square bolt)Always keep the rawl plug from being flush with the surface and the collar intact. As other DIY enthusiasts have stated, the approach varies depending on the surface and plug type. By coincidence, the size of an imperial screw head also roughly equates to the gauge. For example an 8-gauge screw has an 8mm wide head…..handy huh? For anything up to the weight of a t-shirt they’ll just about hold but for anything heavier a proprietary fixing needs to be used. Then you’ll need to consider whether to use a smaller gauge screw or drill a larger pilot hole if it’s in wood. In masonry you always have the option to re-drill the hole one size bigger (drilling through the existing wall plug) and use a bigger plug, red up to brown for example. General Tips A screw has a head, a shank and a thread. Its length is measured from the pointed tip of the thread to the part of the head lying flush with the surface it's screwed into. The gauge is the diameter of the shank. Raised-head screws have heads that sit above the surface, countersunk screws have heads that are flush with or sink below the surface. Screws can have slotted or crossed heads - cross-headed screws being easier to drive in than slot-headed ones, especially with a power screwdriver. Screw gauges

Once level, use a screw or other thin pointed object to mark through the fixing holes on the hanging rail to show where you need to drill your fixing holes. The imperial system of screw gauges ranked shank diameter as a number from 1 to 20 - the higher the gauge, the bigger the screw. The metric equivalents are not nearly so user-friendly, but this is how screws are now increasingly sold. Use this handy table as a guide: Gauge The hooks above also feature a handy support to prevent it from dropping. In most cases if you are hanging heavy items, unless the fixing is supported from below as in the hook diagram above, the weight of the item will eventually cause the fixing to drop. Fixing a Batten to the Door

What is a plastic wall plug?

Lay your piece of batten face down and apply several thin beads of construction adhesive across the face of the timber. Why? Because the way a wall plug works and holds in place is by expanding in a radially outwards fashion. Simply put, when you put a screw into a plastic wall plug (or an old fashioned wooden plug for that matter) it acts as a wedge, pushing the two halves of the plug apart and filling the hole very tightly. Friction then takes care of holding everything in place for all eternity; handy stuff friction… and it’s free! An alternative to using a vacuum cleaner is to use a decent hand pump & the inflating needle used for sports & exercise balls. Understanding the nuances of even the most basic tasks, such as how to remove rawl plugs from a wall, is part of mastering the art of DIY home improvement.