STC-1000

Product Information

It has functions of temperature measurement, temperature display, temperature control, temperature correction, sensor fault alarm, over-temperature range alarm, compressor protection delay. A completed Arduino UNO programmer setup. Note that the pinheader is 6 pin, that is what I had around, only 5 pins are used though. Arduino Nano Displej má diody, z nichž jedna ukazuje, že termostat má aktivované relé, které je zapnuto (chlazení nebo topení). další dioda se rozsvítí, když nastavíte termostat nazvaný SET. Then just cut off one end of the dupont cable. Strip just a little bit of insulation off the end of each cable and pre tin. Solder each cable in the correct position (D9, D8, GND, VCC, D3). Best to feed it from below the board, as the reset button (which will still work) and other stuff is on the other side. Elitech STC-1000 Thermostat used in wine fermenter brewing, sausage making, bread fermentation, and sous vide

Micro temperature controller STC-1000is good stable choice .My experience is good with both versions from Elitech work in the hatchery3 thermostats, OEM version I sold about 18 pieces all run reliable. Elitech STC-1000 wirring and operation instruction manual: Once you’ve wired the controller, calibrate it. This is a straightforward process that involves immersing the heat probe in ice-cold water until it reaches a stable temperature. The actual shape of the workpiece iscaptured on the machine using Starrag’sown 5-axis measuring cycles. If measured temperature temperature set-point - temperature differential, the controller starts heating mode and heating indicator is on. Enter 'd' (without the apostrophes) in the serial monitor input field and press 'Send' button. You should then receive:Once stable, set the controller at minus that value. For example, if it stabilizes at +0.5, set it off by -0.5. Process analyses and stability evaluations can be made easily with integrated sensors and evaluation routines.

The Arduino Nano might just be the most cost effective and simple way to go. You'd need to do some light soldering. Under normal operating status, the panel displays currently measured temperature and automatically recognizes and switches cooling and heating modes. The controller has two modes: heating and cooling. The controller’s ability to switch between these modes helps regulate the temperature of your fermenting environment by keeping the temperature within the fermentation vessel stable. STC-1000+ is an open source implementation of firmware(s) for the STC-1000 dual stage thermostat that add improvements and features over the version it is shipped with. It also provides an easy and cheap way of uploading said firmware(s) to the thermostat by emulating a programmer using the widely available Arduino platform. Finally the project adds a few tools that make it easier use and upload the firmware(s).Wiring the STC-1000 can be achieved by connecting a few store-bought loose wires and connectors to the device. Když připojím Termostat do sítě, tak mám na „vstupu 1“ napětí, signálka ukazuje „topení“, ale na vstupech 5 a 6 mi zkoušečka (jednoduchá tužková do zásuvky) neukáže žádné napětí, tj. nesvítí doutnavka.