We will be installing lights to the headlights first. To do this, remove the following pieces from the front of the car. Reconnect the 2×6 plate to the rest of the roof, without the white plate underneath. Then remove the red light with white stud underneath so we can install another flashing Bit Light to it. Ever wanted to create your own LEGO® set? That's exactly what LEGO® Ideas is! Fan-submitted creations have now been turned into actual commercially available sets! Locate 2 of the provided grey plates with clips as we will be replacing the original ones with these. Take another 2 flashing Bit Lights and install them by placing them over the studs and connecting the blue transparent round pieces over the top. Take another expansion board ( expansion board#2) and connect the first group of 6 lights from the front section of the roof to the first available ports on the expansion board.

CAUTION: Forcing LEGO® to connect over a cable can result in damaging the cable and light. Connecting cable connectors to Expansion Boards Take the 2 provided Lego 1×6 white pieces and connect them underneath the roof securing the front and middle roof sections together. This LEGO light up kit contains lighting features such as flashing sirens on the top of the Ecto-1, front and rear headlights, and flashing emergency lights at the rear of Ecto-1. Installation Guide Genuine LEGO® Parts for the Movie-Accurate Replacement Roof Strobe, Motor, and to Hold Adapters and Controllers in Place

Take the front section of the roof and remove the white roof plate from underneath, then remove the transparent blue triangular pieces, followed by the grey pole with attached light pieces.

If there's something strange in your neighbourhood, who are you gonna call? Why the Ghostbusters of course! Repeat this step for the cables from the tail lights, twisting/winding them around each other. We should now have 2 groups of cables. Our light kits come with detailed, step-by-step installation guides to help you add lights to your favourite models. No electronics experience required! Connect multiple kits

LEGO® Technic

Before we hide the 2 cables from the right we will first install an LED to the blue light at the right side window. To do this, remove this section at the grey stud with clip.