Holts LOYGG8RA Gun Gum Repair Bandage

Product Information

Providing the exhaust is securely mounted, and free from leaks, it is not a failure if an exhaust bandage or sealant - such as gum gum is used to repair a leak. If the exhaust manifold is still blowing at the cylinder head, fitting a new gasket is our next suggestion. Loose exhaust clamps

If an exhaust is blowing from a join, it may be possible to tighten that connection to seal it. Exhaust clamps can sometimes rattle loose. Or perhaps the wrong size of exhaust clamp is fitted, which means it won’t seal the connection. Our specially developed Metal Repair Bandage is an easy to use solution for wide, straight pipes. Always use together with Holts Gun Gum paste for a permanent, gas tight seal.A large hole in an exhaust system isn’t so easy to fix with a bandage, exhaust paste or anything else. In most cases, the only answer is to replace that section of the exhaust system. Repair exhaust sections When looking for the source of a blowing exhaust, remember that the fumes are dangerous and harmful. So make sure there’s plenty of ventilation. Exhaust manifold blowing With this method, you don’t need any special tools and you don’t need to take the exhaust apart. All you need is the ultimate exhaust repair kit: the Gun Gum Exhaust System Repair Paste and the right bandage. What Gun Gum product should you use?

They should be considered a temporary repair, but can last for many months if applied correctly. I have found that a good seal can be achieved if you wrap some tin plate around the damaged section before applying the bandage. If you have heatproof gloves, it may be safe to hold the exhaust where you think it’s blowing. This will help to muffle the bit that’s blowing and find the cause.The Holts range of Gun Gum exhaust repair products makes it easy for you to fix any section of exhaust on your driveway. The Holts Gun Gum Flexiwrap Silencer Repair is fully flexible exhaust repair solution. You can adjust it as needed for as tight a seal as possible, allowing you to repair holes and damaged areas easily. No need to dismantle your exhaust, simply fit the flexiwrap for a permanent gas tight seal in minutes. Features & Benefits: If an exhaust system is blowing around a join, it may be possible to seal it with exhaust paste. This helps to fill any gaps where a clamp is fitted. Dismantle the join, clean it with a wire brush, then apply some exhaust paste. Reassemble the join, fitting a new clamp if necessary. In some cases, running the engine will enable the exhaust paste to dry as the exhaust warms up and thus you have a fix for your blowing exhaust. Flexi-sections

yeah, itll pass. dont mention it to them though, emmisions is your only worry as exhaust is loaded with its own pressure in the test....OEM car speakers can be a little underwhelming, especially if you own an older car. We take a look at everything you need to know about the different types of car speakers before you upgrade. The Easy Fit Metal Repair Bandage is an exhaust repair kit from our Gun Gum range containing an adjustable wrap which can be fitted to bends in sections of exhaust or where a silencer box meets a pipe. I had a rust hole in the pipe in front of the silencer and patched it with repair tape. The repair was perfect and very long lasting, but unfortunately the pipe continued to rust underneath the bandage. The repair was gas-tight right up to the day the exhaust pipe snapped in half. Spraying soapy liquid over a join or where the exhaust manifold mates to the cylinder head can also help. If air is blowing out of where you spray, it will be easier to spot the soapy liquid. This may turn into frothy bubbles, which are even easier to see.