The amount of adjustability provided by door hinge jigs depends very much on the type. Very basic cabinet hinge jigs are simply used to mark hole positions, and any adjustment is manual. More advanced models have rotating cams that give different spacings from the edge of the door. These jigs are usually one size to suit the hinge being used—either 35 millimeters (mm) or 26mm—though some can accommodate both. As mentioned there are a few other sizes of concealed hinge including 40mm, but these tend to be for more heavy weight specialist applications. How Many Concealed Hinges Should you use on Each Door?

Templates | Blum Templates | Blum

I’d have to measure my forstner bit tomorrow at work, but I’m thinking that the hole must be pretty darn close to 1/2 deep! Try googling ‘blum cup hinge spacers’ to see if that is what you’re looking for. Mounting plate: The mounting plate is fixed to the cabinet framework or carcass. The hinge then slides on or clips on the mounting plate holding the door in place Once positioned accurately mark screw holes, drill a pilot hole and screw it in place. Repeat for any remaining hinges. Fit Cabinet Door to Unit or Framework I’m going to test a board, but I think the female portion of the hinge needs to go in deeper than the 20mm for corner cabinets.

The jig can flex if too much pressure is applied when routing, so care is needed. Unfortunately, the included router bit is not very good and soon loses sharpness. Those with numerous doors to hang may wish to invest in a better cutter. Buying a door jig is the easy option, but with care, it is possible to make your own. In fact, for cabinet doors, a jig isn’t strictly necessary. If you can measure and mark accurately, hold the drill vertically, and judge the depth of a hole, then a Forstner bit of the appropriate diameter to match the hinge is all that is required. Owners of pillar drills will find the task easier, but a portable drill and a steady hand can get the job done. Yes, the hinge position is usually the same on all the doors. It’s only the door height and width which are variables. Oh, and the middle hinge position on tall or full height doors on larders etc.

Hinge and Mounting Plate Jig - Cup Sizes 26/35mm

Before explaining exactly how to measure and fit a concealed cabinet hinge to a kitchen or bathroom cupboard it’s important to fully understand each different part of the hinge and what it’s called so that when we refer to a particular part you’ll know exactly what we mean: Calling the Everbilt template a cabinet hinge jig is a bit of a stretch, but as a low-cost way to mark out cabinet hinge positions, it works fine. It also includes the necessary Forstner drill bit, though not the 1/16-inch bit for hinge retaining screws.

Is the Cabinet Door Fitted Internally or Externally (Overlay or Inset)?

Insert the 35mm forstner bit into your drill and then position the point of the guide directly onto the point that the two lines cross. As you are sliding it in place ensure all the others also line up with their respective mounting plates. If the door you are using is particularly heavy it’s a good idea to get some help fitting it to avoid any disasters. If you’re using the IKEA Ultrusta cabinet hinge from the new Sektion system, here are a few measurements you’ll need to fashion your template. Drill the hole in the door with a 35mm hinge cutter for your drill or router. Want to use the new style, IKEA Ultrusta cabinet hinges from the new Sektion system on a custom build project? So why not invest in the best hinge jig from Kreg AND their class leading drawer slide jig and cabinet hardware jig?